1 LOTOS TIG200 TIG/Stick Welder
10 HAND-HELD SHIELD, WIRE BRUSH, ETC. ARGON REGULATOR ARGON HOSE FOOT PEDAL
11 POWER SUPPLY RATINGS TIG200 General Specification Output Power AC/DC Input Voltages 110/220V ± 15%, 1-PH, 50/60Hz Input Current 15A @110V, 30A
12 WHAT YOU NEED TO OPERATE THIS MACHINE? A properly grounded 110-120 VAC 50/60 hz. Circuit or a 220-240 VAC 50/60 hz. 30-50 amp Circuit. Reme
13 MACHINE REAR The unit is connected to the supply even if the Power Switch is on the “OFF” position, and therefore there are electrica
14 INSTALLATION PLEASE READ ENTIRE INSTALLATION SECTION BEFORE STARTING INSTALLATION. BE SURE THAT ONLY QUALIFIED PERSONNEL SHOULD PER
15 SETUP INSTRUCTIONS ELECTRIC SHOCK can be fatal Have a qualified electrician install and service this equipment. Turn the input power
16 INSTALLATION DIAGRAMS
17 TROUBLESHOOTING PLEASE READ AND UNDERSTAND THIS ENTIRE SECTION. SERVICE AND REPAIR SHOULD ONLY BE PERFORMED BY TRAINED PERSONNEL FOR YOU
18 OUTPUT CURRENT CANNOT REACH RATED VALUE Deviation of power voltage from the rated value will lead to unconformity of output current value wit
19 Arc Cannot Start Make sure the machine is securely grounded. Use the right type of Tungsten. Make sure there is enough gas flow.
2 TABLE OF CONTENTS SAFETY...………………………………………………………………………..4 SPECIFICATIONS…….………………………………………………………..9 General Description…………………………………………………………..9 W
20 OTHER ACCESSORIES The following accessories and consumables can be purchased on www.uwelding.com, or call 408-739-2329 to order. ACC
3 TIG200 TIG/STICK WELDER
4 SAFETY WARNINGS AND PRECAUTIONS PLEASE READ AND UNDERSTAND THE FOLLOWING SAFETY HIGHLIGHTS. BE SURE THAT ALL INSTALLATION, OPERATION, MAINT
5 instructions for lubricating and changing accessories. Inspect tool cords periodically and, if damaged, have them repaired by an authorized techni
6 ELECTROMAGNETIC FIELDS may be dangerous The EMF field that is generated during arc welding may interfere with various electrical and elect
7 ARC RAYS can be dangerous Use a shield with the proper filter (a minimum of #11) to protect your eyes from sparks and the rays of the
8 CYLINDER may explode if damaged Use only compressed gas cylinders containing the correct shielding gas for the process used and properly o
9 SPECIFICATIONS GENERAL DESCRIPTION This compact, dual-voltage, versatile TIG200 offers user a simple array of controls to accurately s
Commentaires sur ces manuels